SG8819527002 Ratchet wrench.
3 captive screws and 13 pins.
Loosening/Tightening tool assembly for inlet cone
This tool is used to install and remove the inlet cone from the module 02 – Compressor.
Black anodized aluminium and blued steel.
This documentation contains important safety notes and instructions on use about Squirrel’s Garage SL special tools. In-proper use of tools and non-observance of these safety notes can lead to personal injury and property damage.
Completely read, understand and observe the safety notes before use.
Employers are responsible for the safe condition of tools and equipment used; they must notify supervisors and replace damaged tools. Socket wrenches shall not be used when jaws are sprung to the point that slippage occurs. Keep floor as clean and dry as possible to prevent accidental slips or trips when working with Squirrel’s Garage special tools.
|Terms & conditions||
Limitation of Liability
Parts and Warranty
Loss or damage that occurs during shipping by a carrier selected by Squirrel’s Garage SL is on Squirrel’s Garage SL responsibility. Loss or damage that occurs during shipping by a carrier selected by Customer is Customer’s responsibility.
This document, as well as the data, specifications and other information set forth in it, are the exclusive property of Squirrel’s Garage SL. It may not be reproduced or given to third parties without its consent. The data specified above only serve to describe the product. No statements concerning a certain condition or suitability for a certain application can be derived from our information. The information given does not release the user from the obligation of own judgment and verification. It must be remembered that our products are subject to a natural process of wear and aging subject to change.